Dock for the Square Reader for Contactless and Chip

The grey Bosstab Dock is compatible with both generations of Square Reader for contactless and chip.

Square Reader for contactless and chip (2nd generation) with Bosstab Dock for Square Reader (sold separately).

Bosstab Dock for Square Reader for Contactless and Chip (1st and 2nd generation)

To get started with the Bosstab Dock, review the steps below:

1. Locate the two buttons on either side of the outside cover. Push the two buttons simultaneously and slide the cover upwards to remove it. 

2. Place your Square Reader for contactless and chip with the card slot facing downwards along the slope. The charging port and power button should be aligned with the higher part of the dock.

3. Place the outer cover back on until the cover clicks to lock into place.

4. Plug the power cable to the back of your Square Reader for contactless and chip through the access opening in the back of the dock.

Note: The USB cord included with the Square Reader measures 31.5 inches. You can purchase an extended 6.5 foot cable in the Square Shop.

Dock for Square Reader (1st generation)

The Dock for Square Reader (1st generation) allows you to accept payments while keeping the reader charged and secure.

Note: The Dock for Square Reader is no longer available for sale and is only compatible with Square Reader for contactless and chip (1st generation).