System updates

We’re experiencing issues that may affect your Square services. We’ll continue to update our status page with more information.

Home>Troubleshooting

Troubleshoot Your Barcode Scanner

Review these tips to troubleshoot your Bluetooth or USB barcode scanner.

Troubleshoot Bluetooth Barcode Scanners

  • Confirm you’re using an iPad or iPhone with a Bluetooth scanner. Android devices aren’t supported at this time.

  • Check that your scanner is fully charged.

  • Make sure the scanner is paired to your iOS device and not to another device.

  • Check that Bluetooth is turned on within your iOS settings. If enabled, turn it off and back on.

What do the lights mean?

Socket Mobile Bluetooth Scanners come with two indicator lights, a green light for battery and a blue light for bluetooth.

Green Battery Indicator Light

Solid Green Battery is charging or is at least 25% charged
Solid Orange Battery is 25%-10% charged
Solid Red Battery is less that 10% charged
Blinking Red Battery is low and charge immediately

Blue Bluetooth Indicator Light

Blinking twice per second Scanner is looking for pairing connection
Blinking once per second Scanner is trying to pair with a previously connected device
Solid light Scanner paired
No light Scanner failed to pair

Reset your Bluetooth Barcode Scanner

You can also factory reset your Bluetooth barcode scanner. To do so:

  1. Turn on the barcode scanner.

  2. Press and hold the trigger button while pressing the power button. After 15 seconds, the scanner will beep.

  3. Release the trigger button. The scanner will beep 5 times and power off.

  4. Turn the scanner back on and scan the barcode below:

Hard reset barcode for Socket Mobile 7ci scanner

Troubleshoot USB Barcode Scanners

In case you’re having trouble connecting your USB scanner, give the following troubleshooting steps a try:

  1. Make sure your Square hardware (Square Stand, Square Register, or Square Terminal) is plugged into an hardware hub, and that the hub is plugged into a power adaptor.

  2. Clear the hardware hub of any debris or dust.

  3. Plug the USB scanner into a different port on the hardware hub.

  4. Refer to the Quick Start Guide included in the packaging of your USB scanner. Select the quick guide specific to your USB scanner.

If you’re having issues with your USB scanner and aren’t receiving any error messages, you’ll want to try restoring the factory settings.

For the Zebra scanner:

  1. From page 3 of the Quick Start Guide, scan the barcode labeled Set Factory Defaults while the scanner is plugged into the USB hardware hub.

  2. Unplug the USB scanner and plug it back into the hardware hub.

If you connect your USB scanner and receive an error message that states “USB DEVICE IS NOT COMPATIBLE,” or your scanner appears to not be recognized by the Square device, you’ll need to ensure that your scanner is set to the right mode. To do so:

  1. From page 4 of the Quick Start Guide, scan the barcode labeled USB Keyboard HID while the scanner is plugged into the hardware hub.

  2. Unplug the USB scanner and plug it back into the hardware hub.

If you do not have the Quick Start Guide that was included in the original scanner packaging, print a copy from a compatible device. You are unable to scan the included barcodes from a monitor or screen. If you continue to experience issues with your hardware, you can contact Motorola at 1-800-653-5350. Honeywell’s support can be contacted directly at 1-800-782-4263.

Note: If you are having trouble pulling up your onscreen keyboard, double click the power button on the scanner.